小型灑水車?yán)裙收吓懦椒òl(fā)布時間：故障排除方法一

Release time of mini sprinkler horn troubleshooting method: troubleshooting method

按下喇叭開關，如果喇叭有時響，有時不響，多是喇叭開關內部的觸點接觸不好，使用時間過長，觸點間隙增大?？梢栽囍{(diào)節喇叭上的調節螺母，如現象還不能排除，是喇叭質量的問題，需要更換喇叭。

Press the horn switch, if the speaker sometimes ring, sometimes not ring, more than the inner contact of the switch is not good, the use of too long, the contact gap increases. Can try to adjust the adjusting nut on the horn, such as the phenomenon can not be ruled out, is the quality of the horn, the need to replace the speaker.

小型灑水車?yán)裙收吓懦椒?/p>

Small sized sprinkler horn troubleshooting method

故障排除方法二

Trouble shooting method two

按下喇叭出現沙啞聲音沙。多是由于插頭接觸不良，特別是方向盤周?chē)母鱾€(gè)觸點，由于使用頻繁，容易使觸點出現磨損。調節方向盤各個觸點間隙。

Press the horn appeared in a hoarse voice of sand. Is due to poor contact, especially in the direction of the contact around the disk, because the use of frequent, easy to make contact wear. Adjust the steering wheel each contact gap.

故障排除方法三

Trouble shooting method three

按下喇叭開關完全不響。**先檢查保險絲看是否熔斷，然后拔下喇叭插頭，用萬用表測量在按喇叭開關時此處是否有電。如果沒有電，應檢查喇叭線束和喇叭繼電器；如果有電，則是喇叭本身的問題，此時也可以試著調節喇叭上的調節螺母看是否能發聲，如果還是不響，則需要更換喇叭。

Press the horn switch does not ring. First check the fuse to see whether the fuse, and then pull off the horn plug, using a meter measurement in the horn switch when there is electricity. If there is no electricity, should check the horn and horn relay wiring harness; if there is electricity, is the horn itself, this time also can try to adjust the speaker on the adjusting nut to see whether it can sound, if you still don't ring, you need to replace the horn.

故障排除方法四

Trouble shooting method four

關閉喇叭開關，喇叭仍然響個不停。此時要停車檢查線路，關閉電源總開關。檢查從電瓶到喇叭之間的線路，處理破裂線段?，F(xiàn)象即可排除。

Turn off the horn switch, the speaker still ring. At this time to stop the inspection lines, the main power switch off. Check the line between the battery and the horn, and deal with the broken line. Phenomenon can be ruled out.